Was going to mount the data plate to the new flat firewall panel, but then remembered the owner card slot the top of the grill support. Didn't attach permanently as I may want to move it later.
Monday, July 5, 2010
Cuts and More Cuts...
Cut holes in the flat plate today... Got the holes for the master done, got the drain pipe welded in. (GM put two but I'm going to try just one.) Got the flange for air to pass from the plate to the blower mounted. Spritzed some black paint on it, mounted some sticky insulation tape and applied some RTV, then bolted it in place. Opps, snapped off one bolt. I'll have to see if I can extract it from inside.
Was going to mount the data plate to the new flat firewall panel, but then remembered the owner card slot the top of the grill support. Didn't attach permanently as I may want to move it later.
Was going to mount the data plate to the new flat firewall panel, but then remembered the owner card slot the top of the grill support. Didn't attach permanently as I may want to move it later.
Subscribe to:
Post Comments (Atom)
Posts
No comments:
Post a Comment